215C - Fluke Scope/Meters





215C - Fluke Scope/Meters

Based on the 199C and 196C Color ScopeMeters, the 225C and 215C offer the full functionality of those instruments yet with the addition of powerful test capabilities for a wide variety of Industrial Bus systems. When in Bus health Test mode, these ScopeMeters automatically make an analysis of the electrical signals passing through the bus, and compare the parameters to standard values as described in the industry standards for that bus type. Alternatively, the user may select an ‘Eyepattern’ display to visually check the overall signal quality. Parameters are automatically qualified as ‘good’, ‘weak’ or ‘bad’ based on a comparison to the appropriate industrial standards or to user set reference values. Each of the measured parameters is presented with momentary value and with statistical minimum and maximum values measured over time. The reference values used are also displayed, to give the user an easier grip on the systems behaviour. Tested parameters include signal amplitudes, bias voltage, rise- and fall-times, jitter, distortion and noise levels (in-band noise as well as out-of-band noise) depending on the requirements of the associated industry standard.
Specifications
Display Count
5000

Measurements
DCV, ACV, Resistance, Continuity, Diode, DCA, ACA, Frequency, TRMS, Temperature, Duty Cycle, Pulse Width, dBm

Bandwidth
100.0 MHz

Sample Rate
1.0 GSa/sec

Display
144 mm full-color LCD, with backlight, 320 x 240 pixels, 12 divisions of visible screen width

Prestige Test Equipment Inc is an independent distributor and is not affiliated with Agilent Technologies.


Copyright © 2019 Prestige Test Equipment. Powered by Zen Cart